Cleaning Methods For Spiral Finned Tube Equipment

Sep 19, 2026

Leave a message

Safety Preparations Before Cleaning
Shut down the equipment and disconnect the power supply; depressurize and allow the unit to cool; close the inlet and outlet valves for heating/cooling media and drain any residual fluid from the tubes; wait for the equipment to reach ambient temperature before proceeding.
Verify the finned tube material (e.g., galvanized steel, carbon steel, stainless steel) in advance; inspect the integrity of the fins, welds, and flanges; and apply protective measures to vulnerable areas.
Lay down waterproof sheeting or place a collection tray beneath the equipment; prepare tools such as soft-bristled brushes, neutral cleaning agents, and a high-pressure water gun (equipped with a fan-spray nozzle).

 

Physical Cleaning Methods (Suitable for surface dust and fibrous debris)
Soft-bristle brush and vacuum cleaner: Gently brush along the direction of the fins while using a vacuum cleaner to remove loose dust; do not use hard tools like wire brushes, as they may scratch the anti-corrosion coating.
Compressed air purging: Clean thoroughly, working from top to bottom and inside out to clear dust from gaps and hard-to-reach areas, preventing re-accumulation or clogging.
Low-pressure water rinsing: Maintain water pressure between 0.3 and 0.5 MPa; use a fan-spray nozzle to slowly rinse the fins from the side; avoid spraying directly at close range to prevent fin deformation or damage to the coating.

Send Inquiry
Contact usif have any question

You can either contact us via phone, email or online form below. Our specialist will contact you back shortly.

Contact now!