Core Faults in the Main Forming Unit
Weak or Cracked Seam Closure: Causes include worn forming rollers, residual anti-rust oil on the steel strip, or forming deviations due to changes in material weight after switching powders. Solutions: Promptly replace worn horizontal forming rollers; thoroughly clean oil/grease from the steel strip before wrapping; adjust roller pressure to ensure a seam engagement angle of ≥45°.
Uneven Core Material Filling:Causes include powder clumping due to moisture, large impurity particles, or material bridging/clogging at the hopper outlet. Solutions: Install an 80-mesh screen at the hopper outlet; strictly control powder dryness; activate the vibration motor to assist material flow; ensure filling rate deviation remains within ±1.5%.
Frequent Steel Strip Breakage: Causes include weak welds at strip joints, sharp burrs along the forming path, or excessive tension settings. Solutions: Align and securely weld strip joints; grind down sharp edges/burrs on forming guides; reduce uncoiler braking tension; process joints at low speed as they pass through the rollers.
Main Unit Stalling Under Load: Causes include excessive roller pressure, seized bearings, or VFD current threshold set too low. Solutions: Loosen roller pressure; inspect roller housings for abnormal heat and replace damaged bearings; increase the VFD current limit; extend the acceleration ramp time.
Coiling and Spooling System Faults
Disordered or Tangled Spooling: Causes include unsynchronized traverse mechanism reversal, unstable spool tension, or coil unraveling due to handling impacts. Solutions: Match traverse speed to the main unit's line speed; calibrate torque motor output; use protective measures during handling to prevent collisions; rewind and reorganize immediately if tangling occurs.
Coiling Slippage and Wire Pile-up:Causes include loose drive chains, worn coiling roller surfaces, or an unsecured spool mandrel. The corrective measures involve tensioning the drive chain, cleaning oil and grime from the surface of the take-up roll, and tightening the expansion sleeve on the spool mandrel to ensure constant tension throughout the entire take-up process.
